* Updated descriptions to be a little more descriptive.
* Updated store_loot calls to inform the user where the
loot is stored.
* Removed newlines in print_* statments -- these will screw
up Scanner output when dealing with multiple hosts.
Of the fixed newlines, I haven't see any output, so I'm not sure what
the actual message is going to look like -- I expect it's a whole bunch
of newlines in there so it'll be kinda ugly as is (not a blocker for
this but should clean up eventually)
Added targets for 8 specific targets that I've tested: Cisco WAP4410N,
Honeywell WAP-PL2 IP Camera, Netgear DG834, Netgear DG834G, Netgear
DG834PN, Netgear DGN1000, Netgear DSG835, Netgear WPNT834
Added functionality to the CmdStagerEcho mix-in to support encoding via
octal instead of hex based on the :enc_type option. This is because many
devices would not output hex encoded values properly.
Added options on a per-target basis for the PackFormat (endian pack()
values for communication), UploadPath (because /tmp wasn't always
writable), and PayloadEncode (previously mentioned octal encoding
option)
Note for some reason, some devices communicate over one endianness, but
then require a payload for the other endianess. I'm not sure what's
causing this, but if those specific combinations are not used, the
exploit fails. More research may be required for this.
Migrated the Sercomm module to use the CmdStager mixin to provide
uploading of the ELF binary.
Modified the CmdStagerEcho mixin to allow bypass of the "-en " since in
this case, the device messed up when it was used, and would actually
write the "-en " to the file, from some flaky busybox version of "echo".
sinn3r